Dealing with Running Toilets
Contrary to what most people think, fixing a running toilet can almost be a no-brainer. This article will teach you how to find the root of the problem and solve it accordingly. Plumbing may seem like an untamed beast but don’t worry. Fixing a running toilet is pretty much as straight-forward process and you can easily figure it out even if you don’t have any experience with it. You can now start fixing your toilet so you can stop wasting water.
The problem of having a running toilet can sometimes be frustrating. Don’t worry. Plumbers OKC will help you with the clues so you can stop the leaks whether they are continuous or not. To get started, you should first know what most hardware stores have everything you need repairing almost every problem in your plumbing system. One of the most common causes of a running toilet is a broken flapper. If water is still seeping through the flapper when it’s close then you have a broken flapper.
To start replacing the flapper, you have to first turn off the water supply valve which can be found under the toilet. If you have the water valve is broken then turn off the main water supply valve. Drain the toilet tank by flushing the water and remove the old flapper. Get a new flapper that has the same size and shape as the old flapper and install it as instructed in the manual. These flappers are relatively cheap, and any Plumbers OKC home improvement store will carry them. Lightly hook the chain of the flapper to the lever so it doesn’t pull the flapper up when the lever is down.
If the water still runs even if there is no leak in the flapper then you should check the fill tube. The fill tube is connected to the overflow pipe. Don’t let terms like”flapper” and “fill valve” overwhelm you. If you ever feel that the job is too much for you to handle, you can simply contact Plumbers OKC to assist you. See to it that the end of the fill tube is above the water line. If it is below the water line then you should cut it back. Once you’re done, check the fill valve for any damage and check the float. If the float is not adjusted properly, the water line can rise above the overflow pipe which causes the water to run. If this is the case, then adjust the float and replace the fill valve accordingly. Also replace the fill valve if it either doesn’t shut completely or interferes with the float-arm movement.
Replace the old fill valve and install a float-cup style fill valve.
Make adjustments on the float based on the instructions written in the. Carry out the installation by hooking the flapper chain to the flush lever as instructed. If the end of the valve is under water, turn it on and cut it back. Check the fill valve any wear and tear damage and inspect the float. Remember, you can always call an experienced Oklahoma City plumber if you need some direction. If the float is not properly adjusted, can cause the water level to go above the overflow pipe and drain water out through it which causes the water to run. If the fill valve either doesn’t shut firmly or disrupts the movement of the float arm then replace it with a new one.